Tips for Efficient Lysis of Tissue Samples Using the Monarch® Genomic DNA Purification Kit

Get helpful tips for effective lysis of tissue samples to optimize DNA extraction using the Monarch Genomic DNA Purification Kit

Script

Sample lysis is an important and often overlooked step during the purification of genomic DNA. Cell membranes and extracellular matrix components must be fully disturbed, and proteins and RNA must be completely degraded to ensure gDNA is fully exposed and available for capture by the column. Lysis of tissue samples can be especially challenging. In this video, we will provide some tips to ensure the proper lysis of your tissue samples. The success of the lysis step is dependent on input amounts, which differ based on the tissue type. Using excess material can overload the buffer chemistry and clog the column, resulting in low yields and poor DNA quality. For example, DNA-rich tissues like spleen, liver and kidney will become extremely viscous during lysis, which can prevent efficient digestion of the tissue if recommended input amounts are exceeded. Please reference our recommendations for sample inputs online to ensure that you use the correct amount. When you are ready to begin processing the tissue, the samples should be cut into small pieces and processed in a 1.5 ml microfuge tube. After adding Tissue Lysis Buffer and Proteinase K, the samples should be mixed thoroughly. Make sure there are no tissue pieces sticking to the bottom of the tube, as they will not lyse efficiently. If there are pieces on the bottom of the tube, vortex the tube to suspend them. When lysis is carried out using a thermal mixer, it is usually complete within 30-60 minutes. You can proceed from here with the purification procedure and you will have excellent results. However, if time isn’t limiting, lysis can be extended for up to 3 more hours to obtain even higher yields and the lowest possible RNA content. If you do not have a thermal mixer, you can use a heat block. Vortex the sample every 20-30 minutes to speed up lysis. Lysis is complete when the tissue pieces are gone. RNase A should be added at end of the lysis step, to prevent it from being degraded by the proteinase K. By the time lysis is complete, the RNA is released from the tissue and is readily accessible for enzymatic degradation. When working with fibrous or fatty tissues, or with samples stabilized with RNAlater, free floating insoluble fibers will form during lysis, producing a turbid appearance. If these fibers are not removed prior to loading the lysate onto the column, they will stick to the membrane and prevent DNA binding, effectively reducing yield and quality. To remove the fibers, centrifuge the lysate for 3 minutes at maximum speed and transfer the supernatant to a fresh tube before adding binding buffer. For some of these tissues, the recommended input amounts are lower in order to minimize fiber formation. If these inputs are exceeded, it may not be possible to sufficiently remove them. We hope that these tips have been helpful. If you have any questions, our scientists are ready to help. Contact us at info at NEB.com.

Related Videos

  • Tips for Successful GenomicDNAExtractionfromBloodSamples
    Tips for Successful Genomic DNA Extraction from Blood Samples
  • Lysis Tips
    Post-lysis Tips for Optimal Results using the Monarch® Genomic DNA Purification Kit
  • Monarch Handling
    Tips for Handling and Storing Tissue Samples Prior to DNA Extraction
Visit NEB’s Video Library
Loading Spinner